Second Marvin print

3D Printing
1

Hello everyone, a few days ago I printed Marvin, the print was wrong, I was wrong to set up and I had not following the advice of this forum … Yesterday I printed Marvin again following all the forums advice and this time I am very excited about the result, what should I do now? I deleted the old photos and put the new ones in the same place, okay? Now i just have to wait for the actual review?

Thanks

VERO’s Hub

2

I would say you would be best off to contact 3Dhubs directly and tell them what you did and see where you are in the process. They may be able to reset the process if needed.